Filter Installation
Cartridge, sand and DE pool filter systems supplied and installed, sized to your pool volume with the right media and a clean manifold.
Most filter and pump trouble starts on the day the equipment went in. A filter too small for the pool, a pump oversized for the plumbing, unions that were never aligned, and you spend the next decade chasing pressure and noise. We supply and install filtration systems and pumps as one matched set, sized to your pool volume and turnover.
Whether the old unit finally gave up or you are replacing tired equipment before the season, we handle the whole pump and filter replacement, including new plumbing, valves, unions and the electrical hookup. Pool pump replacement cost depends on the pump you pick and the plumbing behind it, so you get a clear written quote before any work starts. Serving Seattle, Bellevue, Kirkland, Renton and the entire Puget Sound area.
One crew for the whole job, so the filter, the pump and the plumbing are matched instead of pieced together.
Cartridge, sand and DE pool filter systems supplied and installed, sized to your pool volume with the right media and a clean manifold.
Worn out or seized pump pulled and replaced with a correctly sized new pump, wired, primed and running the same day.
Old single speed pump swapped for a quiet variable speed pool pump that costs far less to run through the season.
New pipe, valves and unions around the new equipment, laid out so the next service call takes minutes, not hours.
Putting in a heater, salt system or smart controls at the same time? We do those too, see heater installation, salt water systems and pool automation.
It depends on the size of your pool, the equipment you choose and the shape of the existing plumbing and electrical. Most filter and pump installations fall in a predictable range, and we give a clear written quote after looking at your equipment pad. Call (206) 202 1454 for a free quote.
Filter size is based on your pool volume and the turnover rate you want, and it should always be matched to the pump. An undersized filter clogs constantly and an oversized pump pushes water through too fast to filter well. We calculate both together so the system runs efficiently.
Cartridge filters are the most common choice for Seattle backyards, they filter fine and use no backwash water. Sand is the lowest maintenance and easiest to live with. DE filters give the clearest water but need more upkeep. We walk you through the trade offs before anything is ordered.
For most pools, yes. Variable speed pumps run quieter, use far less electricity at low speed and often pay for themselves in energy savings within a few seasons. They also pair well with automation if you want to control the pool from your phone.
A straight filter or pump swap is usually a single day. A full equipment pad rebuild with new plumbing, a heater and electrical work typically takes two to three days, and we tell you up front how long your pool will be down.
Yes. We install and replace spa pumps, filters, heaters and control packs on portable and in ground hot tubs, swim spas and cold plunges across the Seattle area.
Pool pump replacement cost depends on the horsepower and whether you move to a variable speed pump, plus the shape of the existing plumbing and wiring. A like for like single speed swap is the most affordable, and a variable speed pump costs more up front but pays it back in energy savings. You get a firm written quote before we start. Call (206) 202 1454 for a free quote.
Yes. We install and replace pumps and pool filter systems on both in ground and above ground pools, matching the flow rate to your pool so the water turns over cleanly without straining the equipment.
Already have equipment that just needs attention? See filter service, pump repair, cold plunge and swim spa service, pond and waterfall service or the full list of pool and hot tub services.
Free quotes, fast answers, and a real person on the other end.